Penguin

This device cannot show the 3D view. Follow the step pictures and text below instead.

1. 

   1. Crease the diagonal

   Colored side up as a diamond. Fold the left corner to the right corner and unfold.

2. 

   2. Turn over

   Turn over so the white side is up.

3. 

   3. Fold the sides in (belly)

   From the top point, fold both sides toward the center, leaving a V-shaped gap for the white belly.

4. 

   4. Turn over

   Turn the model over again.

5. 

   5. Fold the side corners in

   Fold the side points in a little. These become the flippers.

6. 

   6. Fold the bottom point up

   Fold the bottom point up to make a flat base.

7. 

   7. Fold in half

   Fold the left half over onto the right half.

8. 

   8. Head: outside reverse fold

   Pre-crease the top point at an angle, then wrap it down around the outside to form the head and beak.

9. 

   9. Stand it up

   Open the body slightly so it stands. Your penguin is done!