Cicada

This device cannot show the 3D view. Follow the step pictures and text below instead.

1. 

   1. Fold into a triangle

   White side up as a diamond. Fold the bottom corner up to the top corner.

2. 

   2. Fold the side corners up

   Fold the left and right corners up to the top corner to make a diamond.

3. 

   3. Make the wings

   Fold the top points of both flaps down at a slant. Each crease runs from a side corner to a point a little below the center, so the tips stick out past the bottom.

4. 

   4. Fold the top layer down

   Fold only the front layer of the top triangle down, so its tip lands a little below where the wings meet.

5. 

   5. Fold the next layer down

   Fold the remaining layer down too, a little higher than the first one, so a white V-shaped band shows.

6. 

   6. Fold the sides behind

   Fold both sides behind. Each crease starts on the top edge and slants outward toward the bottom. Your cicada is done!